点击这里给我发消息
 
机械过滤器系列
+ 石英砂过滤器
+ 活性炭过滤器
+ 多介质过滤器
+ 除铁锰过滤器
+ 碳钢过滤罐
袋式过滤器系列
+ 袋式过滤器
精密过滤器系列
+ 不锈钢精密过滤器
+ 保安过滤器
离子交换器系列
+ 阴离子交换器
+ 阳离子交换器
+ 混合离子交换器(混床)
+ 软化水设备
水箱
+ 不锈钢水箱
+ 无菌水箱
反渗透净水设备
农村饮用水设备
不锈钢膜壳
柴油海油类油品脱色罐
 
联系人:汪芳
电 话:13868161524
          13454121895
邮 箱:781981113@qq.com
新闻动态
缓释消毒器操作注意事项
发布日期:2018/5/18  浏览次数:1041 [返回上一页]
缓释消毒器操作规程
Operating procedure for slow-release sterilizer
(1)、设备运行中的检查:
(1) inspection in the operation of the equipment:
1、操作面板数据是否正常。(温度,频率等)
1, the operation panel data is normal. (temperature, frequency, etc.)
2、检查进气量是否正常,反应釜液位及反应液颜色是否正常。(保证有充足的反应时间)
2, check whether the intake volume is normal, whether the reaction tank liquid level and the color of the reaction fluid are normal. (ensure that there is sufficient reaction time)
3、检查计量泵声音及机温是否正常有无泄露。
3. Check whether the sound and temperature of the metering pump are normal or not.
4、检查水浴液位是否正常。
4, check the water bath level is normal.
5、检查氯化酸钠及盐酸罐液位是否正常。(不要低于计量泵中心线)
5, check whether the level of sodium chloride and hydrochloric acid tank is normal. (don't be lower than the center line of the pump)
6、观察出液管单流阀是否有异物及动作是否灵活。
6, observe whether the liquid pipe single flow valve has foreign bodies and whether the action is flexible.
7、防爆塞是否正常。
7, the explosion-proof plug is normal.
8、出液管温度是否正常。(不低于35℃)
8, the temperature of the outlet pipe is normal. (not less than 35 degrees C)
(2)、开机:
(2).
1、检查水浴及反应釜内液位应在1/2处。(液位管)
1. Check the water bath and the level of the reactor should be at 1/2. (liquid level tube)
2、开启温控器使水浴温度升至设定温度。(50℃左右)
2. Open the thermostat to raise the water bath temperature to the set temperature. (about 50 C)
3、排除计量泵内空气并校定计量泵(校定应以背压阀后出液量为准,同时应保持同一机器的两台泵计量泵背压一致)背压应高于进口最大压力1bar。
3. To eliminate the air in the metering pump and to calibrate the metering pump (calibration should be based on the back pressure of the back pressure valve, and keep the same machine's two pump backpressure), the back pressure should be higher than the maximum inlet pressure 1bar.
4、调整动力水压力至稳定状态,使水射器稳定工作。
4, adjust the dynamic water pressure to stable state, so that the ejector works stably.
5、运行计量泵,并逐步调整至所需流量。
5, run metering pump and gradually adjust to the required flow rate.
6、待运行稳定后调整反应釜处于液位。(保证最少反应时间30分钟以上)
6, after stable operation, the reactor is in the liquid level. (ensure that the minimum reaction time is more than 30 minutes)
7、观察反应釜液位管颜色,单流阀工作状态及出液管温度是否正常。
7. Observe the color of the liquid level tube of the reactor, whether the working state of the single valve and the temperature of the outlet pipe are normal.
(3)、关机及发生器清冲:
(3), shutdown and generator cleaning:
1、停止计量泵工作。
1, stop the work of metering pump.
2、打开进水阀,稀释反应釜内反应液浓度将反应釜内浓度降至安全浓度(反应釜内颜色基本无色),关闭进水阀。
2, open the inlet valve, the concentration of the reaction liquid in the dilution reactor reduces the concentration of the reaction kettle to the safe concentration (the color of the reactor is basically colorless) and closes the inlet valve.
3、停止水射器工作。
3. Stop the water ejector.
4、停止水浴加热。
4, stop the water bath heating.
5、将进气孔用堵死,从安全塞进水,将反应釜内注满水浸泡十分钟,后将水从排污阀排出。
5, block the intake port, plug in water from safety, immerse the reactor with water for ten minutes, then drain the water out of the drain valve.
6、重新进水至反应釜1/2处。(液位管)
6, reinfluent to the reaction kettle 1/2. (liquid level tube)
(4)、原料的配制与添加:
(4), the preparation and addition of raw materials:
氯化钠:
Sodium chloride:
1、氯化酸钠配制工作人员应穿戴好防护用具。
1, sodium chloride preparation staff should wear protective equipment.
(防酸碱工作服、护目镜、口罩、防酸碱手套、长统胶鞋)
(anti acid and alkaline work clothes, goggles, masks, acid and alkali resistant gloves, rubber shoes)
2、配制过程中有严禁吸烟及明火。(不许使用摔砸等方法)
2, there is no smoking and open fire in the process of preparation. (not to use wrestling and other methods)
3、配制过程必须按照氯化酸钠与水按1:2的比例混合。(例如:1公斤氯化酸钠加2公斤水)
3, the mixing process must be mixed according to the ratio of sodium chloride and water to 1:2. (for example: 1 kg of sodium chloride with 2kg of water)
4、必须保证氯化酸钠完全溶解。
4, it is necessary to ensure that sodium chloride is completely dissolved.
5、配制后的液体经比重检测合格后方可抽入原料罐中。(例如:1260kg/m320℃)
5. The prepared liquid can be pumped into the raw material tank after passing the specific gravity test. (for example: 1260kg/m320 C)
上一页
友情链接:小型发电机|DJ-6电火花检测仪|热镀锌钢板水箱